花开棋牌

欢迎光临无锡盛发地坪科技有限公司官网!【环氧地坪_防静电地坪_停车场地坪_耐磨地坪花开棋牌】材料生产,销售和施工的高新技术企业.

    示例图片三
    网站花开棋牌 > 新闻资讯 > 地坪知识

    当地面遇水不能进行环氧地坪施工怎么解决?

    2019-09-09 13:56:37 无锡盛发地坪科技有限公司 阅读

    环氧地坪材料基层做防水,那么如何选择上好的防水材料呢?在环氧层施工中,底涂层应选用质量好的材料:让一部分环氧渗透到基层或防水层中,上下形成一个整体。提高粘结力,固化后少留残余化学物质或气体。环氧施工完后避免阳光的照晒,减少环氧层表面和里层之间的变化。在基层或防水层上施工一定要把残留的灰层杂物等清洁干净。施工后防水层和基层之间不得留有空隙。懂一点环氧地坪常识的用户都知道,环氧地坪漆施工地面混凝土的含水率一般低于8%,过高的含水率会严重影响环氧地坪的施工质量,会使环氧地坪花开棋牌出现涂膜附着力差、表面鼓泡、脱层等不良现象。 如上所述,基层的部分水汽、环氧残留物和气体被包裹在环氧和基层内,形成大小不一的气泡,由于环氧层本身不透水汽,水汽不能排除,留下气泡的症状。

    花开棋牌In the construction of epoxy floor, the bottom coating should be made of good quality materials: let part of epoxy penetrate into the base or waterproof layer and form a whole up and down. Enhance the bonding force, leaving less residual chemicals or gases after curing. After the epoxy construction, avoid sunshine and reduce the changes between the surface and the inner layer of the epoxy layer. In the construction of the base or waterproof layer, it is necessary to clean the residual ash layer and other debris. No gap shall be left between the waterproof layer and the base after construction. Users who know some common knowledge of epoxy floor paint know that the moisture content of concrete used in epoxy floor paint construction is generally less than 8%. Excessive moisture content will seriously affect the construction quality of epoxy floor, which will lead to poor adhesion of coating film, surface bubbling, delamination and other undesirable phenomena. As mentioned above, some water vapor, epoxy residues and gases in the base layer are wrapped in the epoxy and base layer to form bubbles of different sizes. Because the epoxy layer itself is impervious to water vapor, water vapor can not be eliminated, leaving behind the symptoms of bubbles. 

    1、ZUOFANGSHUICENG:DUIYUHANSHUILVJIAOGAO,QIEHANSHUILIANGYOUBUDUANSHANGSHENGQUSHIDEHUNNINGTUJIMIAN,XUYAOZUOZHUANYEDEFANGSHUICENG,FANGZHIHOUQISHENSHUIERDAOZHISHIXIAO。

    花开棋牌1. Make waterproofing layer: For concrete foundation with high water content and rising trend of water content, professional waterproofing layer is needed to prevent late seepage from leading to floor failure.

    2、保持施工现场通风:施工现场保持通风状态,空气的循环流动可以加快混凝土基面中水分的挥发,有利于提高环氧地坪漆与基面的粘结力。

    2. Maintain ventilation in construction site: keep ventilation in construction site. Circulating air flow can accelerate the volatilization of moisture in concrete base surface, which is conducive to improving the bonding force between epoxy floor paint and base.

    3、JIARE(YONGHUOKAO)TIGAOHUNNINGTUJIMIANWENDUTIGAOKEYIJIAKUAISHUIFENDEZHENGFA。DIPINGDINGZHIJIANYISHIYONGKONGQIJIAREHUOSHIFUSHEJIARE,BUNENGCAIYONGHUOYUANJIARE,YINWEIHUOYUANJIAREHUIZENGJIAKONGQIZHONGWUDIANWENDU,SHISHUIQIZAIHUNNINGTUZHONGNINGJIE。

    花开棋牌3. The evaporation of water can be accelerated by increasing the temperature of concrete base surface by heating (roasting). Floor customization is recommended to use air heating or radiation heating, not fire heating, because fire heating will increase the temperature of the air fog, so that water vapor in concrete condensation.

    4、TOUSHIXITONG:TOUSHIXITONGYOUJIGAODESHUIFENTOUGUOLV,KEBAOZHENGJIMIANSHUIQITOUGUOTUCENGYICHU,BIMIANTUCENGQIPAOTUOLUO,SHIYONGYUWUFAANZHUANGFANGSHUICENGDEJIMIAN。

    4. Humidity permeability system: The moisture permeability system has a very high water permeability, which can ensure that water vapor on the base surface escapes through the coating and avoid the foaming and falling off of the coating. It is suitable for the base surface which can not be installed with waterproof layer.

    WEILEFANGZHIHUANYANGCENGQISHUIPAO,JIUYAOZAISHIGONGZHONG,DUJUESANJIANSHI:SHUI、BAOSHAI、HUICENG。GONGSIRENWEIYINGGAICAIQURUXIAFANGZHISHUIPAOCHANSHENGDECUOSHIZAIDICENGJICENGZUOFANGSHUICENG,FANGZHISHUIQIXIANGSHANGSHEN,YANGEKONGZHIJICENGHUOFANGSHUICENGNEIDEHANSHUILV8%YINEI,KANGYAQIANGDUDAYU20mpa,RANHOUZAIJINXINGHUANWEISHIGONG。TIGAOHUANYANGCENGHEJICENGHUOFANGSHUICENGDEZHANJIELI,KEFUCHUQISHUIPAOSHIDEZHANGLIBIMIANSHUIPAODEFASHENG。

    花开棋牌In order to prevent foaming of epoxy layer, three things should be eliminated in the construction of epoxy floor: water, sun exposure and ash layer. The company believes that the following measures should be taken to prevent the formation of bubbles in the bottom of the grass-roots waterproof layer, to prevent water vapor seepage upward, strictly control the moisture content of the grass-roots or waterproof layer within 8%, compressive strength greater than 20 mpa, and then carry out sanitation construction. Improve the bonding force between epoxy layer and base or waterproof layer, overcome the swelling force at the beginning of bubbles and avoid the occurrence of bubbles.

    KANGSHENBUTOUQIXING,KANGYAXING,QIANGDUDAYU20MPA,HEDIMIANYOUCHAOQIANGDEZHANJIEXING,HEHUANYANGSHUZHIRONGYIZHANJIEXINGCHENGYIGECHAOQIANGDEZHENGTI。LINGWAI,FANGSHUICENGZAISHIGONGWANGONGHOU3TIANNEIBUDESHANGRENSHOUZHONGYADENG。NEIDIMIANCHAOSHIYINGRUHECHULINI?XIAMIANYOUBENXIAOBIANGAOSUNINHUANYANGDIPINGDIMIANCHAOSHIDECHULIFANGFA!

    花开棋牌Seepage and impermeability, compressive resistance, strength greater than 20 MPA, and the ground has a strong bonding, and easy to bond with epoxy resin to form a super-strong whole. In addition, the waterproof layer shall not be subjected to heavy pressure within 3 days after completion of construction. How to deal with the moisture on the epoxy floor? The following is a small edition to tell you how to deal with the moisture on the epoxy floor!



    标签:   环氧地坪 地坪 环氧地坪漆 环氧地坪施工 无锡环氧地坪
    无锡环氧地坪 技术支持: